This will delete you message, are you sure ?
Sticky thread : On / Off
Lock thread : On / Off
This will delete this thread, are you sure ?
Forum : Parties : Coding GPIO high/low input pins on Scratch
Hi,
I am completely new to scratch and I was wondering what the most simple way of coding GPIO high/low input pins were? I was hoping to implement cases where, when a certain GPIO pin is low, a note is played from the midi sound system using a pHAT DAC with a Raspberry Pi Zero. Any help would be greatly appreciated.
Please help.
I didn't find the right solution from the Internet.
References:
https://www.raspberrypi.org/forums/viewtopic.php?f=63&t=207478&sid=eb078a178e2be71f6b91908da29c4206
Booking software video
Thanks
I am completely new to scratch and I was wondering what the most simple way of coding GPIO high/low input pins were? I was hoping to implement cases where, when a certain GPIO pin is low, a note is played from the midi sound system using a pHAT DAC with a Raspberry Pi Zero. Any help would be greatly appreciated.
Please help.
I didn't find the right solution from the Internet.
References:
https://www.raspberrypi.org/forums/viewtopic.php?f=63&t=207478&sid=eb078a178e2be71f6b91908da29c4206
Booking software video
Thanks